New Case

[Nycz]

NZXT H6 Flow with Kraken 360 AIO

 

Kept the xfx rx 7700xt gpu. Needed a better case and cooling more.

[Totty]

Looks nice, kudos to you for getting up at 06.22 to take a pic

[Nycz]

Thanks. It was 6:22pm though. Lol

[KaptCrunch]

very nice case 

i hate tell that how rad is placed is big air trap when coolant level drops leaves no heat transfer from less contact to tubes. best move the rad with fans blowing outward of the front corner of case with bungs up and  move 3 fans to the top of case bllowing inward  also turn cpu 180° so that can be self priming and 2 bottom fans blow inwards.

oh forget to say get a fan cotrollier that has  4 channels  and min, 1 amp per channel  note your AIO  fan is 12V DC, 0.23A (2.76W) = x3 .23A = .69 Amps gang them parrelle, do the same with 3 upper now formally front corner and 2 lower fans case fans just check watts rating per fan convert to amps, stay within ! Amp by 10%.

also the rear fan blow inward  after all done use a inferad temputer gun an check heat pattern and adjust fan speeds   

Edited 6 hours ago by KaptCrunch
adding fan controllier

[KaptCrunch]

i would add a  water reservoir after warranty runs out  Note:  not made of Acrylic material for will crack with heat cycles or any alchol like the typoon3  PC water reservoir did for they used my design after i set them up for notice they were using my ideals without payment or acknowledgement, jokes on them 

[Nycz]

its a AIO, no water cooler plus everything you just said is opposite of what is online and has been tested for years. Rear and top fans always blow out with front/ bottom in. the only real possible change but not with this case is moving the aio to front to get barely any cooler air in with just 3 fans top still going out.